30
8
Correcting Faults
8
Correcting Faults
8.1
Fault Finding and Troubleshooting
There is a fault present if the "ERR LED" flashes or lights up continuously. In the event of a
fault, the alarm relay output is closed.
A fault is not reset automatically. To reset a fault, the device supply must be disconnected. To
do this, disconnect the F130l for at least 5 seconds from the mains and then switch it on again.
NOTICE
Check the settings and connections
Check the input and output terminals of the flame monitor for proper configuration and
connection.
Check inputs and outputs for short-circuit and interruptions.
NOTICE
Permanent fault
If a fault cannot be reset, please contact the LAMTEC maintenance and repair department
for assistance.
Only the maintenance and repair department may perform repairs.
8.2
Information About the Repair Service
Please contact LAMTEC Service/Support if you have any questions.
LAMTEC GmbH & Co.KG
Sensors and Systems for Combustion
Technology
Wiesenstraße 6
D-69190 Walldorf
Hotline: +49 (0) 6227 / 6052-33
email: [email protected]
Содержание F130I
