Lamtec ETAMATIC V, Быстрая справка

Страница: 14 / 30

13
4 Operation
4.8 Operation and Display of the O2 Trim
When you have switched to "Status", the display shows the O
2
actual value and O
2
setpoint
value. The display shows the values in brackets, if O
2
trim is deactivated.
NOTICE
O
2
actual value and O
2
setpoint are only displayed, if O
2
trim or O
2
display are activated in
parameter 896.
In automatic operation, the display switches during regular operation automatically to O
2
trim
mode. However, it is always possible to switch the display over with key "M". The manually
preselected setting only remains in force until the next switch to "Regular operation” or "Base
firing rate operation”, and then returns automatically to the base setting.
4.9 Calling up O
2
Trim Text Messages
Switch display to O
2
trim
4.10 Displaying the Running Time Meter
Press key 15 once, to switch the display to O
2
-trim.
Mode "O
2
-trim": By pressing key "ENTER" (display in position "Status"), you can call up
information texts (running texts)
press key "RESET"
press key M
press key "ENTER" to call up the text messages
press key "ENTER" again → back
press key 10 → the display shows the running text of the following data succes
-
sively:
Total running time
Running time on curve set 1
Starts on curve set
Running time on curve set 2
Starts on curve set 2
Running time on curve set 3*
Starts on curve set 3*
Running time on curve set 4*
Starts on curve set 4*
* if parameterised