Lami Corporation Rose-63CL, Инструкция по эксплуатации

Страница: 11 / 14

10
①Turn on the power switch in the back of the machine.
②Turn the handle to the left side and pull down the laminate roller.
③Insert the test scripts toward the laminate roller for test laminating processing.
Adjust the wanted speed using speed control dial.
If wrinkles are formed in the processing material, set the film again or,
adjust the pressure or speed again.
④After completion of test laminate processing, start to laminate original scripts.
■In case using low temperature function
①Turn on the heater switch which is in the most right in operation panel.
When turning on the button, heater LED is lit up and lump in the left part of the machine
is illuminated.
②Press the Set button and set the adequate temperature 0 ～ 60 ℃.
When present temperature reaches set temperatur, Prepare LED is lit up and
lump in the left part of the machine is extinguished.
This mode means ready for laminate processing.
After test laminate processing, start to laminate original sctripts.
【４】Perform laminate processing
③Turn the handle and pull down the laminate roller.
※When using winding device,attach finish material with sticky tape.
Laminate film
Release paper
Insert Direction
Underfilm
Figure seen from right side
①Underfilm is passed through, Signboard→Laminate roller→Winding device
②Laminate film is passed through Laminate roller and set release paper on the paper core.
【３】Install the laminate film by referring to the figure below