aem.eco
LAMBRECHT meteo
|
AEM
|
u[sonic]WS6
page
–
9
Wind Vane:
The wind vane blades can be removed after loosening the three screws of each blade. After mounting of
the new parts the wind vane has to be balanced. For this purpose the sensor must be held in a horizontal position (90°
shifted from the position during normal operation). If the balancing is correct, the vane will be stable in every position.
The adjustment can be made with the weight at the end opposite of the vane. It can be moved after loosening the
threaded pin. Please be sure that all screws are fixed before mounting the sensor on the mast again.
4.2 Repair procedures
The fault tracing and service work only should be carried out by skilled maintenance personnel having passed a
factory training at our facilities or a similar course. All spares of the sensor mentioned here which cannot be repaired
have to be disposed appropriately according to the local instructions of the waste management. For all other repairs
which cannot be carried out by own staff the sensor has to be returned to our factory .The full shipping address of our
company is mentioned in this operating instructions.
4.3 Ordering spare parts
In case that the mentioned spares are required for replacement or to be put on stock, please pass us the following
information in order to send the right spare parts:
•
Ordering number/parts number
•
Required quantity
•
Related component or name of higher assembly
A detailed inquiry containing these information will be appreciated by us for the safe identification of the required
items and to prevent wrong deliveries. Above mentioned data can be obtained from the designation label.
5.0 Set device out of operation
5.1 Storage
The wind sensor 24513-NMEA has to be stored in a clean and dust free room with temperatures between -40 and
60 °C (not con densing) in the original cardbox or a similar packing.
5.2 Dispatch
We recommend using the original box or similar packaging for shipping. To prevent damage during transport, the
wind vane and the cup rotor must be protected.
5.3 Remarks
This manual describes the standard design as well as possible options. The respective performance will be stated
in the specification and/or the commercial documents of the contract. Our products are subject to continuous
developments. Technical alterations for the technical progress are reserved.
