Lambda Labs - Professional Acoustics CX-1A/B Manual
2.2.1.7.
Amplifier
Module
&
DSP:
Module
Cover
„S“
Mounting
To
protect
the
Control
Panel
from
unauthorized
access,
a
module
cover
can
be
installed.
To
do
this,
follow
the
instructions
below:
1. Remove the 4 x M4 DIN 912 screws with a
ratchet or an electric screwdriver. Keep the
screws and the M4 washers and M4 snap
rings at a safe place. Always start removing
the M4 Screws in the corners and follow an X
order to unmount the other screws to avoid
excessive stress in the Amplifier Module’s
heatsink!
2. Put the Module Cover „S“ over the Control
Panel area and reinsert the removed parts
from step 1. To properly install the module
cover, follow the order of the parts as shown
in the drawing:
a) M4 washer
b) M4 snap ring
c) M4 DIN 912 screw
3. Fix the screws with a torque of
1,5
Nm
and
follow an X order to mount them. Do not
start the order with a corner screw to prevent
any damage to the amplifier module.
!
16
a)
b)
c)
•
Ratchet
or
electric
screwdriver
•HEX
BIT
Number
3
(Wrench
Size
3mm)
R
