LAMAX eLander SA50, Руководство пользователя

Страница: 7 / 84

4 5
EN
CS
CZ
CZ
CZ
CZ
CZ
CZ
1. Battery charge status
2. Current driving mode
3. Current speed
4. Total distance travelled
5. Mode button
6. Main POWER button
6. ASSEMBLING AND FOLDING THE SCOOTER
Assembly
1. Carefully remove the scooter from the box, place it on the ground and fold out the kickstand. Adjust the
handlebar post to a vertical position so that the lock and post latches engage and check that the mechanism
is properly secured
2. Attach the handlebars by tilting the folding mechanism towards the handlebar post.
3. After assembling the scooter, test the functionality of the brakes and the strength of the joint at the handle-
bar post. Press the main POWER button and test if everything is working properly.
4. Then turn off the scooter and charge it.
Folding the scooter
1. Lift the folding mechanism lock up and release it by pulling it away from the handlebar post.
2. Lower the handlebar post towards the rear fender.
3. Then insert the hook on the handlebars into the lock on the rear fender.
7. CHARGING THE BATTERY
The battery is the most important part of the scooter. Electric scooters are equipped with lithium-ion cells.
Unlike lead acid batteries, these batteries are able to provide better functionality and longer life. They are
lightweight and have high performance. However, these batteries also have a life cycle. In order to maximise
their lifespan, it is important to take care of the batteries regularly.
–
Only use the original charger from the manufacturer supplied with the scooter to charge the battery.
–
If the battery indicator shows a low battery, connect the scooter to the charger.
–
Always make sure the charging port is clean and dry before charging. If the charger is not connected to the
scooter, the power input must always be covered with the rubber cap to prevent dust or other debris from
entering the input.