CFU139
CEDAR LOG GLIDER
Please check contents before assembly.
If any items are missing or damaged,
do not take the unit back
to the store.
Call 1-800-427-5136 for customer service and we will save you time by correcting any
problems directly for you.
NOTE:
•
Read all instructions before starting.
•
Do not completely tighten any screws until the
unit is fully assembled and setting on a level
surface.
•
Use a rubber mallet (or a block of wood between
the hammer and the unit) to drive doweled ends
into holes as far as possible.
CEAR LOG GLIDER COMPONENTS
LOG GLIDER HARDWARE
(Shown smaller than actual size)
NOTE:
Cracks or Checks in logs are part of the natural
beauty of cedar logs and should not be considered defects.
TOOLS REQUIRED
Lay assembled seat on floor. Insert dowel
end of uprights on assembled back into holes
on the back seat rail, adjust uprights in or
out as needed to align properly. Do not tap on
seat back with hammer.
To keep the seat rail from splitting, lay the
back on the floor and drive the seat onto the
dowelled ends by hitting on the bottom of the
seat assembly.
STEP 1
2 Glider End Assemblies
Rail 57” Long
Preassembled Back
6 Braces
9” Long
2 Back Legs
26” Long
2 Arms
20” Long
Preassembled Seat
1 Left
Front Leg
26” Long
1 Right
Front Leg
26” Long
STEP 2
Make a right leg set and a left leg set by
inserting dowel end of back leg into angled hole
of front leg. The drilled holes on each leg should
face the same direction as shown in figure 2.
Put arms onto legs by inserting dowel end of front
legs into the hole in the arms. Drive arm onto leg
assembly as far as possible.
figure 1
figure 2
