CF1009 TETE-A-TETE PORCH SWING
Please check contents before assembly.
If any items are missing or damaged,
do not take the unit back to the
store.
Call 1-800-427-5136 for customer service and we will save you time by correcting any problems directly
for you.
TETE-A-TETE PORCH SWING HARDWARE
TETE-A-TETE PORCH SWING COMPONANTS
2 - Preassembled Seat Backs
2 - 45” Swing
Bars
Preassembled Swing Seat
2 - 24” Arms
2 - 12”
Arm Supports
2 - 21-1/2”Seat Ends
2 - 9-1/2” Front
Table Supports
Table Top
NOTE: Cracks or Checks in logs are part of the natural
beauty of cedar logs and should not be considered de-
fects.
Right
Left
”
4 - 1/4” x 5”
Hex Washer
Head Screw*
18 - 2 1/2” Screws
2 - Barrel
Nuts
2 - 3/8”
Washers
2 - S Hooks
2 - 3/8” x 5” Eye Bolts
* Lag Screws and Washers may be substituted for Hex Washer
Head Screws
TOOLS REQUIRED
Tape
Measure
Pencil
Rubber Mallet or Block
of Wood & Hammer
#2 Phillips Screw-
driver & Regular
Screwdriver
7/16 Socket or Wrench
NOTE:
Using a battery
Or electric power drill with a socket
attachment
will make
assembly easier and faster.
Read all instructions before starting
.
Helpful Tips:
To start hex washer head screws, hammer into
wood about 1/2” then use wrench or socket to
tighten.
Do not completely tighten any screws until the unit
is fully assembled and setting on a level surface.
If you have hardware left over after completing
your unit, it most likely has been assembled incor-
rectly, and may not be safe to use. Please call
Customer Service at 1-800-427-5136, for assis-
tance.
A battery operated or electric drill will make as-
sembly faster and easier.
Use a good quality penetrating oil or wood deck
sealer with a UV inhibitor & an anti-fungal. (Make
sure product is intended for outdoor use.)
If staining or finishing before assembling, tape off
all dowel ends. (Finishes will cause the dowels to
swell, making assembly difficult
Check all nuts and bolts for tightness before
and during each usage season.
Figure 1
Install seat ends onto seat. Align holes in seat end with
dowels on seat . Repeat on other side. Secure with screws
perpendicular to dowel. IMPORTANT: The single hole
should be placed toward the front of the seat. (See right).
Figure 1. Secure with screws.
STEP 1
Please Note
: After you have installed the seat ends onto the seat
secure with (4) 2 1/2” screws.
