LAI Games VIRTUAL RABBIDS THE BIG RIDE, Руководство оператора

Страница: 43 / 115

43
INSPECTING BASE STATIONS
CHECK FOR DIRT OR DAMAGE
When looking at the face of the base stations, check to make sure they are clean and scratch free.
This can affect their communication.
CHECK CHANNELS
The base station channel is visible in the bottom left hand corner of the base station face, as shown
below. The two base stations must be set to different channels. The correct channel can be found by
checking the stickers near the base stations. Use the button on the back of the base station to toggle
between channels. You should never need to change a base station channel unless you are replacing
the part.
Note that the channels shown below are an example only. Please check the stickers on your unit to
confirm your correct channel configuration.
STATUS LIGHT
At the top centre of the base station face, there is a small light that indicates the current status of
the base station.
•
Green
o
Normal operation. The base station is turned on, synced with the other base station.
During normal operation, status lights on both base stations should always be green.
•
Blue
o
The base station is waiting to stabilize. This means it has received impact or vibration,
which will prevent it from syncing. Open the base station housing and ensure the base
station is securely positioned and has not come loose. Also check the levelling feet
underneath the sled have been adjusted to touch the floor, ensuring the sled is stable
when touched.
•
Purple
o
The base station is trying to sync. This status may be visible briefly after start up, or after
a blue status light has been seen. It means the base station has recovered and is trying
to re-establish syncing with the other base station.