LAI Games Let's Bounce, Руководство оператора

Страница: 40 / 90

40
COUNTERS
Counters will increment for each coin inserted and each ticket paid out. Counters are under
firmware control and are not directly connected to the mechanisms.
BUTTONS
Press the green SERVICE/BACK button to issue a service credit from attract mode. Press and hold the
green SERVICE/BACK button to enter temporary Free Play Mode. This will remain in place until
machine power is reset.
Press the red TEST/ENTER button to enter the operator menu from attract mode.
When in the operator menu, use four up/down/left/right buttons to navigate through the menu.
VOLUME KNOB
Use to adjust the speaker’s sound level.
COIN MECHANISM / BILL ACCEPTOR / CARD SYSTEM
Credits can be inserted via a coin mech, bill acceptor and/or card system connection. All interfaces
are located inside the front coin doors.
TICKET MECHS
Tickets won are paid out from two ticket mechs. Being a 2-player game, tickets are paid out on the
mech corresponding to the player. Player 1 tickets are paid out on ticket mech 1 and player 2 tickets
are paid out on ticket mech 2. The exception being when the “Card System” game setting is set to
ON. If a 2-player game is played by crediting only a single player position then all tickets are paid out
on that players ticket mech.
PLAYFIELD FUSES – FB214
Each tile on the playfield receives an independent power and data connection. Each tile is fused by
the FB214 PCBs which are located behind the side panel.
GAME BOARD – FB216
The FB216 is the main control board for the game. It contains the application firmware and output
drivers to control the lamps, displays and tiles.
SOUND BOARD – FB106
The FB106 is the sound driver board containing the sound files and amplifier. Volume is adjusted by
the potentiometer on the operator panel.
BALL DISPENSER
The ball dispenser is a 2-stage mechanism consisting of a ball lifter and a ball gate.
The lifter is a rotating plate to lift the ball to the ball gate. Balls are counted by the FB84 IR Sensor
PCB.
The ball gate is used to hold the balls before dispensing them to the player. Gate position is detected
by the FB165 sensor PCB.