laguna SHEARTEC II PX-22, Руководство пользователя

Страница: 33 / 83

Calibrating the Thickness Scale 33
Calibrating the Thickness Scale
NOTICE!
The following procedures describe the use of a “Calibrating Board.” It is a piece of hardwood which
has been surfaced on one side with a jointer, drum sander or wide belt sander.
With the Planer “OFF”
• Make sure the cutter head is not rotating.
• Disconnect Power, place the Calibrating Board on the table, with the previously machined (flat) face “down.”
• Slide under the cutterhead.
Thickness Scale Calibration
1.) Use the Table Height Adjustment handle (Fig. A) to raise the table until the infeed roller is “approximately
1/16” above the calibrating board.
2.) Remove the calibrating board from the planer.
3.) Connect power to the planer and turn “ON.”
4.) Turn the height adjustment handle clockwise, one complete revolution, to lower the carriage and run the
calibrating board (previously machined face “Down”) through the planer.
5.) Repeat Step 5 until the planer removes the entire top surface of the calibrating board.
NOTICE! Drawing pencil marks across the width of the top of the calibrating board in several locations
can make it easier to determine when the entire surface has been planned.
6.) Measure the thickness of the calibrating board with a caliper.
7.) Loosen the two screws of the Thickness Scale pointer and adjust the pointer
(Fig. B) until it corresponds to the
measured thickness and then tighten the screws.