laguna SHEARTEC II PX-22, Руководство пользователя

Страница: 22 / 83

PX-22 SHEARTEC II PLANER 22
Power Supply Circut Requirements
The power source circuit for your machine must be grounded and rated for the amperage given below. Never replace
a circuit breaker on an existing circuit with one of higher amperage without consulting a qualified electrician to
ensure compliance with wiring codes. If you are unsure about the wiring codes in your area or plan to connect your
machine to a shared circuit, consult a qualified electrician.
DANGER!
IN ALL CASES, MAKE CERTAIN THE RECEPTACLE IN QUESTION IS PROPERLY GROUNDED.
IF YOU ARE NOT SURE, HAVE A QUALIFIED ELECTRICIAN CHECK THE RECEPTACLE.
Motor Specifications:
The typical main motor is 7.5 HP and is typically wired for 220 Volt, Single Phase, 60 HZ, AC current. Confirm your
motor electrical configuration before connecting power! Before connecting the machine to the power source, make
sure the starter and switches are in the "OFF" position. Cord and “plug” are NOT included. These must be installed
by a Qualified Technician/Electrician to local codes.
NOTICE! A “Electrical Plug” and “Power Cord” are NOT included and must be installed by a Qualified
technician/Electrician , or the power cable connected (hard wired) to an appropriate disconnect according to local
codes.
WARNING! WHEN COMPLETED, THE MACHINE MUST CONFORM TO THE NATIONAL ELECTRIC CODE
AND ALL LOCAL CODES AND ORDINANCES.
Connecting Power:
1. Remove screws securing cover to connection box.
2. Insert power cable through strain relief, tighten cinch nut and attach wires to terminals.
3. Re-install the Connection Box Cover, see Page XX for Wiring Diagram.
WARNING! DISCONNECT POWER SUPPLY TO PLANER BEFORE CONTINUING! ONLY CONNECT POWER
WHEN REQUIRED.