laguna Sheartec II JX 8, Руководство пользователя, Страница: 34 / 47

32 JX|8 Sheartec:II Jointer \ Troubleshooting
Troubleshooting
Symptom Possible Cause Possible Solution
MACHINE WILL 1. FUSE BLOWN OR CIRCUIT BREAKER TRIPPED 1. REPLACE FUSE OR RESET CIRCUIT BREAKER
NOT START 2. CORD DAMAGED
3. NOT CONNECTED TO POWER SOURCE
4. CONNECTED TO WRONG VOLTAGE
5. EMERGENCY STOP BUTTON PRESSED
2. HAVE CORD REPLACED
3. CHECK CONNECTION
4. CHECK VOLTAGE
5. ROTATE EMERGENCY STOP BUTTON
CLOCKWISE UNTIL IT POPS OUT
CUTTERHEAD
DOES NOT COME
UP TO SPEED
WORKPIECE
DIFFICULT TO
PUSH 1. LOW CURRENT
2. MOTOR NOT WIRED FOR CORRECT VOLTAGE
1. TOO MUCH MATERIAL BEING REMOVED IN
ONE PASS
2. DULL KNIVES
1. CONTACT LOCAL ELECTRIC COMPANY
2. REFER TO MOTOR NAMEPLATE FOR
CORRECT VOLTAGE
1. REDUCE THE AMOUNT OF MATERIAL BEING
REMOVED
2. ROTATE OR REPLACE KNIVES
SNIPE 1. MATERIAL NOT SUPPORTED PROPERLY AS IT 1. SUPPORT MATERIAL FOR ENTIRE CUT
EXITS OUTFEED TABLE 2. ELIMINATE DOWNWARD PRESSURE ON
2. OPERATOR PUSHING DOWN ON TRAILING TRAILING END
END OF MATERIAL 3. ADJUST OUTFEED TABLE LEVEL WITH
3. OUTFEED TABLE TOO LOW CUTTERHEAD ACHIEVED
FUZZY GRAIN 1. WOOD WITH A HIGH MOISTURE CONTENT 1. ALLOW WOOD TO DRY PROPERLY
2. DULL KNIFE INSERT(S) 2. ROTATE OR REPLACE
3. KNIFE INSERT(S)
LINE(S) OR RIDGES 1. NICKED OR DAMAGED KNIFE INSERT(S) 1. ROTATE OR REPLACE
IN 2. KNIFE INSERT(S)
FINISHED SURFACE
Dust Collection
To ensure proper operation and longest knife life it is important to maintain full air flow to your dust
collection system. Make sure the filter media is clean and there are no obstructions in the ducting or
hoses.