laguna 506601, Руководство пользователя

Страница: 27 / 48

27 JX|6 & JX|8 Quadtec:I Jointers \ Troubleshooting
Troubleshooting
Symptom Possible Cause Possible Solution
MACHINE WILL
NOT START 1. FUSE BLOWN OR CIRCUIT BREAKER TRIPPED
2. CORD DAMAGED
3. NOT CONNECTED TO POWER SOURCE
4. CONNECTED TO WRONG VOLTAGE
5. EMERGENCY STOP BUTTON PRESSED
1. REPLACE FUSE OR RESET CIRCUIT BREAKER
2. HAVE CORD REPLACED
3. CHECK CONNECTION
4. CHECK VOLTAGE
5. ROTATE EMERGENCY STOP BUTTON
CLOCKWISE UNTIL IT POPS OUT
CUTTERHEAD
DOES NOT COME
UP TO SPEED 1. LOW CURRENT
2. MOTOR NOT WIRED FOR CORRECT VOLTAGE 1. CONTACT LOCAL ELECTRIC COMPANY
2. REFER TO MOTOR NAMEPLATE FOR
CORRECT VOLTAGE
WORKPIECE
DIFFICULT TO
PUSH 1. TOO MUCH MATERIAL BEING REMOVED IN
ONE PASS
2. DULL KNIVES 1. REDUCE THE AMOUNT OF MATERIAL BEING
REMOVED
2. ROTATE OR REPLACE KNIVES
SNIPE 1. MATERIAL NOT SUPPORTED PROPERLY AS IT
EXITS OUTFEED TABLE
2. OPERATOR PUSHING DOWN ON TRAILING
END OF MATERIAL
3. OUTFEED TABLE TOO LOW
1. SUPPORT MATERIAL FOR ENTIRE CUT
2. ELIMINATE DOWNWARD PRESSURE ON
TRAILING END
3. ADJUST OUTFEED TABLE LEVEL WITH
CUTTERHEAD ACHIEVED
FUZZY GRAIN 1. WOOD WITH A HIGH MOISTURE CONTENT
2. DULL KNIFE INSERT(S)
1. ALLOW WOOD TO DRY PROPERLY
2. ROTATE OR REPLACE
3. KNIFE INSERT(S)
LINE(S) OR RIDGES
IN
FINISHED SURFACE 1. NICKED OR DAMAGED KNIFE INSERT(S) 1. ROTATE OR REPLACE
2. KNIFE INSERT(S)
Dust Collection
To ensure proper operation and longest knife life it is important to maintain full air flow to your dust
collection system. Make sure the filter media is clean and there are no obstructions in the ducting or
hoses.