Laguna Tools MPLAN25-10-1-0130, Руководство пользователя

Страница: 6 / 31

5
Dust Chute Assembly
Mount the dust chute to the planer hood with
eight M6x10 hex head screws B. Make sure
the dust collection system has sufficient
capacity and suction for your planer. Always
turn on the dust collection system before
starting the planer. (Fig. 2)
Table Roller Handle Assembly
Thread the handle C(Fig. 3) into the hub.
Control Panel
In Fig. 3
D: Emergency Stop Button: Stops all
functions of machine, but the planer still
has power. To reset rotate switch
clockwise until the button pops out.
E: Main Motor: Starts rotation of Cutterhead.
Will not work if the “Emergency Stop”
switch is engaged, or hood is open.
F: Digital Thickness Controls: Displays and
controls table position, units, etc..
G: Table Up: Raises the table.
Note: Table will contact the upper limit
switch at about 5/8”. You can continue to
raise manually by using the handwheel.
H: Table Down: Lowers the table.
Note: Table will contact the lower limit
switch at about 8-5/8”. You can continue
to lower manually by using the handwheel.
Digital Controller
In Fig. 4
I: LED readout displays the thickness
setting.
J: The digital thickness controls are capable
of operating and displaying in either
inches, or millimeters by pressing the
“Units” button.
K: The “+” and “-“ buttons can be used to
move the table up or down without keying
in an exact numerical thickness value.
Note: The“-“ button raises the table to
subtract from workpiece thickness. The
“+“ button lowers the table.
L: “Start” button is used to begin table travel
after a numeric value has been keyed in.
M. The “Stop” button is used to stop the
table travel after it has started.
N. The “Set” button is used when calibrating
or setting the thickness scale.