Dake Corporation
1809 Industrial Park Dr
Grand Haven, MI 49417
#972200, 972210, 972220
10
REV#072020
Assembly Instructions: 10 Ton Bench Model
Step 1 (Bench Model Only):
-
Using (2) M8 x 20mm bolts, nuts and washers install the union support to the bottom from of
the upright channels. (Pump hanger bracket on the right-hand side of the upright.) The union
support is to face outward. See drawing below.
Step 2:
-
Carefully stand the unit upright. Making sure all components are square to each other, tighten
all nuts and bolts securely.
Step 3:
-
Mount the head ram transverse plates. The side with two bars welded to them go inside the
frame, with the threaded plate on the bottom. Using 10mm x 120 mm bolts, washers, and nuts,
tighten only enough to allow plate to travel.
Step 4:
-
With press standing upright and all bolts tightened install the worktable. Insert two table pins in
the two lowest holes.
-
Take the worktable and tilt it at a sharp angle and insert it in the uprights.
-
NOTE: The gussets welded to the table are at slight angles. The narrowest dimension of these
gussets goes down. See drawing below for guidance. (Step 1) Once worktable is in the
uprights turn it level and lower down and set it on the table pins. (Step 2)
-
Take care when doing this, a helper would be advised.
