Installation Instructions-Arctic Spas
Step #1
Position the spa cover (in closed position) on the spa,
making sure that all four corners are properly positioned
and square on the spa.
Step #2
Using the #10 X 1” and #10 X 2" screws, attach the left
and right Mounting Brackets to the appropriate sides of
the spa.
Caution:
To prevent splitting of wood cabinet, pre-drill
holes with a 1/16” drill bit.
To determine mounting location of Brackets on the
Coyote Series Spas and the Arctic Series Spas,
mounting height is optional,
(See Fig.1A - 1B - 1C)
on
the opposite side of these instructions.
By positioning the Brackets at 8” down from the top of
the spa shell, approx. 9” clearance behind the spa will be
needed. Mounted at this position approximately 75% of
the spa cover will be standing above the spa surface in
the off position.
By positioning Brackets 12” down from the top of the
spa shell, approx. 15” clearance behind the spa will be
needed. Mounted at this position approximately 50% of
the spa cover will be standing above the spa surface in
the off position.
Step #3
Connect the Pivot Arms to the Mounting Brackets.
(See Fig. 2)
After Pivot Arms are connected tilt them
back into the upright position.
Continued on back...
Figure 2
3/8" Lock Nut
Mounting Bracket
Side Pivot Arm
Washer
3/8"x 3" bolt
Washer
Figure 1A - Installation of Mounting Brackets on
Arctic 7’ and Arctic 8’ Series Cabinets
Figure 1B - Installation of Mounting Brackets on
Coyote 8’ Series
Figure 1B - Installation of Mounting Brackets on
Coyote 8’ Series
