Lacunza AUSTRALIA Verona 1000, Инструкция

Страница: 9 / 29

INSTRUCTIONS FOR THE INSTALLER 8
2.
closable outside-air inlet with a section of
at least 90 cm².
2.2.2. Location of the appliance in the
room
Choose a location in the room which
favours good hot-air distribution by
convection and radiation.
2.3. Installation of the appliance
2.3.1. Floor
Make sure that the base can withstand
the total constructed weight of the
appliance and its casing.
The apparatus should not be placed on
combustible material.
In the case of the Verona 1001
appliance, as a safety measure it is
recommended to fasten it to the ground
using 4 screws. It has semi-cut holes in the
base to perform this operation.
Figure No.5 - Fastening the Verona
appliance to the floor
A minimum 510mm deep x 1015mm
wide x 50mm thick floor protector (Skamol
board) should be used under the appliance
base when installing the appliance (see
joint AS/NZS 2918:2018 3.3.2). A minimum
600mm deep x 1320mm wide x 36mm
thick floor protector (compressed board)
should be used in front of each of the
appliance doors and be placed centrally in
the 1320mm width. The Thermal resistivity
of the 50mm skamol board floor protector
is 0.74m².K/W. The Thermal resistivity of
the floor protector is 0.16m².K/W for
36mm thick compressed board sheets.
Minimum air gap of 50mm must be
maintained under the appliance base to
the Skamol floor protector.
2.3.2. Safety distances
Be sure to respect the appliance
installation distances from combustible
materials .
Bear in mind that it may even be
necessary to protect non-combustible
material in order to prevent breakage,
deformation, etc., as a result of
overheating
if the non-combustible
material is not designed to withstand high
temperatures.
2.3.3. Checks before lighting for the first
time
•
Make sure that the glasses are not
broken or damaged.
•
Make sure that the flueway is not
obstructed with packing or loose parts.
•
Check the deflectors are correctly
positioned.