LABORIE Solar Blue, Руководство по обслуживанию и установке

Страница: 114 / 198

© 2008
– 2020 by MMS B.V.
113
7.5.13 No Bluetooth connection and the Bluetooth LED is off
There is no Bluetooth connection and the Bluetooth LED does not flash.

Connect the power adapter and try again.

Remove one battery and wait 20 seconds before replacing it.

Install new batteries.

Connect another power adapter.

Contact your LABORIE representative.
7.6 Cleaning and Maintenance
In this paragraph, you will find cleaning and maintenance instructions for the
Bluetooth puller.
Cleaning
The Bluetooth puller is designed to prevent most dirt from entering, but does
not cope with continuous wet polluted situations. The cover of the motor
house, in which the slider is confined, can be removed for cleaning purposes.
Removing this part gives access to the plastic pinion that drives the slider. This
pinion is limited in torque and poses no threat to fingers or other body parts.
LABORIE recommends to clean the following parts:

On a daily base, low level dis-infect the slider and the guider in an
instrument (medical) dishwasher with a maximum temperature of 80 °C
(176 °F).

On a daily base, clean the outside of the Bluetooth puller and the carrying
arm with a moisturized cloth.

Remove the cover (control panel) of the puller enclosure if there is dirt
inside the enclosure. Clean the plastic pinion, the cover and the Bluetooth
puller with a moisturized cloth.

The DC receptacle on the Bluetooth puller should be kept clean for optimal
performance.

The Bluetooth puller is drip water proof and resistant to urine, saline,
alcohol, cidex, Biotex green and cleaning detergents.
Cleaning of the slider, guider, plastic pinion and the cover of the motor house
can be done with 70% alcohol.