Laboratory2, LTD
Page9
Version of 09.04.2019
Copy the created file
dict.ini
to the memory card.
Insert the memory card into the voice recorder and switch it on. The voice recorder will
read configuration file and save it to the internal memory. After reading the settings from the
file, voice recorder will automatically remove it and continue to work in a user-defined mode
(indication as shown in Table 3).
2.4
Usage of the voice recorder.
Insert the formatted under FAT32 micro SD card into the voice recorder.
Turn the voice recorder on by pressing the control button for 2 seconds. After turning
on, voice recorder enters the operating mode which has been set by the user at the last setting.
To display the voice recorder current status, briefly press the control button. The cur-
rent state is determined according to the indications on the table. 3.
To switch the recorder off, press the control button and hold it down till the mode indi-
cator stops flashing or goes out (indicator must either begin to turn solid green, or goes off).
Moreover, if the operation has been set for the alarm clock, the operation of all alarms is can-
celed.
After switching the voice recorder off, remove the memory card and insert it into a
card reader. To verify the digital signatures, use the tab "Verifying files integrity" of the pro-
gram dict.exe. Before using program, please, read paragraph. 2.6 of this document.
To listen to the recorded files, use any player that supports "WAV" format (recom-
mended is SOUND FORGE version 6.0 and later).
2.5
Creating a configuration file.
Run dict.exe program and in the opened window select tab "Setting up the voice re-
corder", as shown in Fig. 3. This tab is used to create / read files
dict.ini
and it contains the
following parameters and options:
a)
Enable\disable voice activation (VOX).
When this mode is active, recorder starts re-
cording once the audio level of a sound signal exceeds a predetermined threshold. If the au-
dio level is below a predetermined threshold for 15 seconds, then the voice recorder stops
recording and enters the standby mode of the acoustic signal, without closing of the current
file. Sound recording fragments are consistently registered in the current file (up to 70 frag-
ments in one file). For each voice operated switching the tag indicating date and time of
voice operated activation (the beginning of a fragment) will be created in the file (see para-
graph
3
). Record fragments of voice operated switch will be separated in the file from each
other with either silence, or beep (item 2.5 (
b
)).
b) Beep between fragments
. After switching the voice activated mode on, the user can
choose a way of fragments separation in the current file. In case of setting a tag
"Beep be-
tween fragments",
all sound recording fragments in the current file will be divided by
beeps, or, otherwise by silence. Use of beeps between fragments allows the user to define
aurally the beginning of a new fragment when listening files.
