6
| LABNET ORBIT DIGITAL SHAKERS
Press START/STOP button to start operation. RUN and TIME signal lights. Shaker runs and counts down time from set value.
NOTE:
You cannot modify the set time during shaking; however, you can stop the unit with the START/STOP button and then reset the time.
99.4
STOP
Encoder
POWER
START
RUN
TIME
RPM
Push
Changing the RPM during shaking
Push the encoder knob to put the shaker into RPM set mode (RPM signal light will be on).
100
STOP
Encoder
POWER
START
RUN
TIME
RPM
Push
l l
l l l l l l l
Rotate the encoder knob right (+) or left (-) to set the desired value. In the meantime RPM signal light will flash.
When you stop rotating the encoder knob the signal light for RPM will stop flashing after 2 sec.
When the run time has elapsed or when you press the START/STOP button, End will show on the display, and the Run light will flash.
When the shaker completely stops the set speed and time will return to the last programmed values.
End
STOP
Encoder
POWER
START
RUN
TIME
RPM
Push
l l
l l l l l l l
5.3 Additional Operations
If you want to view the set value for RPM during shaking, rotate the encoder knob for ONE CLICK right (+) or left (-). RPM signal light
will then flash for 2 sec., and the display will show the set RPM and the light will stop flashing.
NOTE:
Shaker must be in RPM mode – RPM signal light must be on.
120
STOP
Encoder
POWER
START
RUN
TIME
RPM
Push
l l
l l l l l l l
If you want to view the set value for TIME during shaking, rotate the encoder knob for ONE CLICK right (+) or left (-). Time signal light
will then flash for 2 sec., and the display will show the set TIME and the light will stop flashing.
