4
| LABNET ORBIT DIGITAL SHAKERS
Labnet Orbit™ 300
Grease
Stabilizers
0.7
mm
Before you attach the platform, make sure that the slide stabilizers are properly fastened, adjusted and lubricated with the included grease.
The flat mat platform has a circle cut-out in the rubber and screw holes in the center. Remove the cutout rubber circle and screw
down the four screws onto the shaker. After attaching the platform, remove the non-adhesive backing paper on the rubber circle
and paste it back into place.
The grease which you use to lubricate the slide stabilizers is sufficient for 1,000 working hours (1 year). After that time you should
remove the shaking platform and clean, adjust, and re-grease the slide stabilizers. If they are worn out, you should replace them
with new stabilizers and set to appropriate height.
Labnet Orbit 1000 and Orbit 1900
The Orbit 1000 and Orbit 1900 shakers have a variety of platforms to meet most shaking needs. These platforms mount to the
shakers via four mounting platforms which easily plug into four rubber mount points on the top of the shaker.
5.0 Operating Instructions
5.1. Control Panel
F50
STOP
Encoder
POWER
START
RUN
TIME
RPM
Push
1
2
3
4
5
6
1. POWER switch:
Turns the shaker ON (power switch illuminates) or OFF
2. RUN green light:
Illuminates when the shaker is running
3. TIME yellow light:
Illuminates when the shaker is set on time
4. RPM yellow light:
Illuminates when the shaker is set on rpm
5. ENCODER:
By rotating the encoder knob right (+) or left (-) you can change the set TIME or RPM. Push the encoder knob to switch
between TIME and RPM set values. If you rotate the encoder knob fast, the values go up or down on the display very quickly
6. START/STOP button:
START or STOP operation
