Figure 42. Software uploaded to the control unit
Press the
Update
button.
The software update begins and the message in the figure below is shown in the display.
The various phases of the software update are presented in the control unit display.
Figure 43. Software update started
Once the programming has been completed, the control unit reboots.
The WLAN connection to the device is lost during a software update.
Establish the WLAN connection again according to the instructions in the
Commissioning
through the browser-based interface
section.
7.3.3.6. Restoring factory settings
In the Factory settings menu you can restore the control unit's original factory settings.
The factory settings of the idOil device are described in the section
Commissioning
Restoring the factory settings clears the alarm and maintenance log. The sensors
connected to the control unit must also be identified again.
Installation and Operating Instructions | idOil Solar
40/58
DOC001599-EN-3
