Shock Dyno
Version: 1.0.23241
Page 16/62
7.1.
Changing the stroke
Follow the steps below to change the stroke on the Shock Dyno. These steps apply to all the Shock
Dyno models.
1.
Press the Emergency Stop Button to disengage the Shock Dyno and prevent the motor from
moving.
2.
Rotate the roller bolt using a wrench (Figure 10 – Step 1) and insert the locking pin to lock
the roller in place (Figure 10 – Step 2).
3.
Unscrew the rolling bolt until it is loose.
4.
Slide the roller to the side to mount it into a different hole on the flywheel.
5.
Tighten the bolt and remove the locking pin to complete the stroke adjustment.
Figure 10
