Shock Dyno
Version: 1.0.23241
Page 14/62
6.2.
Adapter Installation
Whenever installing a new adapter into the Dyno or replacing an existing one, follow the steps
below:
1.
Make sure the Shock Dyno is powered off, or the Emergency Stop Button is engaged before
changing the adapters.
2.
Use a wrench tool to unscrew both vertical bolts to release the clamp heads. (Figure 9 –
Step 1)
3.
Switch to another adapter and use the same method to secure the bolts in place.
4.
Release the Emergency Stop Button if previously engaged.
Figure 9
