37
2.
Follow below diagram to insert all
handle installation accessories into
handle fixation holes:
3. Align the handle with the screws and
tighten the screws until the handle is
aligned with the door and secured tightly
against the door (DO NOT over-tighten
as this will cause damage to the handle
assembly and door glass surface).
4. Restore the door gasket into its
original position to finish handle
installation.
Reversible door SLS102DZ
– SLS102DZS – SLS102DZBLACK
Note that the references SLS102DZ and SLS102DZS correspond to the instructions
below but, unlike the diagram shown, are equipped with an external handle.
This door of the appliance is reversible, the door is set to be hinged right at purchase,
you can change it to the left by following below instructions:
1. Close the door, remove the upper hinge cover and upper hole cover pad on top
side using a flat-head screwdriver.Remove the upper hinge by unscrewing 4pcs
of hex head screws, then remove the door from the cabinet carefully by opening
the door slightly and lifting it up and set it aside. Attention: The door is heavy,
handle it carefully with an assistant.
2. After door is removed, lie down the wine cooler on a soft mat. Remove the lower
hinge at the right bottom and door support at the left bottom.
3. Install the lower hinge to the left bottom and door support to the right bottom.
4. Move the hinge hole cap (at the top of the door) from the left side to the right side.
Move the door stopper (at the bottom of the door) from right side to the left side by
using a Philips screwdriver.
5. Hold the door carefully and place it on top of the lower hinge
6. Install the upper hinge at the left top of the cabinet, and cover the upper hole with
upper hole cover pad.
