26
3.
After the batteries are inserted, the Weather station will start receiving data signal from the transmitter. The
outdoor temperature
and humidity data
should then be displayed on the Weather station. If this does not happen
after 2 minutes, the batteries will need to be removed from both units and reset from step 1.
4.
In order to ensure sufficient 868 MHz transmission however, the distance between the Weather Station and the
transmitter should not be more than 100 meters (see notes on “Positioning” and “868 MHz Reception”).
Note:
In the event of changing batteries of the units, ensure the batteries do not spring free from the contacts. Always wait at
least 1 minute after removing the batteries before reinserting, otherwise start up and transmission problems may occur.
WHEN MORE THAN ONE TRANSMITTER IS USED
1.
User shall remove all the batteries from the Weather Station and transmitters, and wait 60 seconds.
2.
Insert the batteries in the first transmitter.
3.
Within 2 minutes of powering up the first transmitter, insert the batteries in the Weather Station. Once the
batteries are in place, all segments of the LCD will light up briefly
and a short signal tine will sound
. Following the
indoor
temperature/humidity
and the time as 0:00 will be displayed. If these information are not displayed on the
LCD after 60 seconds, remove the batteries from both units and wait for at least 60 seconds before reinserting
them.
