16 |
P a g e
1.
Press SENSOR button once Station ID will show.
2.
Press SENSOR button again ID WTH123 THW SENSOR will show.
3.
Hold the MINUS (-) button for 5 seconds while viewing ID to delete ID WTH123.
To add a separate LTV-TH2 sensor:
•
After deleting the TH sensor built into the Wind Sensor (ID: WTH123), press the SENSOR button on the station
to view ID, then press the TEMP button to search.
•
Press the TX button on the add-on sensor.
•
Sensor Icon
will show to indicate reading is coming from separate TH sensor.
WHAT DOES A READING OF “HI” OR “LO” MEAN?
•
If your outdoor temperature reading shows “HI” or “LO”, check that your
•
Overpowered or underpowered batteries can cause this reading.
•
If batteries are good, replace the outdoor sensor.
•
If your temperature is fine but your humidity is reading “HI” or “LO” or dashes, your humidity may be below
10% Relative Humidity. Your sensor does not read below 10% humidity.
TEMP INTERMITTANT: WHY DOES MY TEMP/HUMIDITY READING COME AND GO?
•
RF (radio frequency) communication may come and go occasionally. This can be normal in some
environments (e.g. moister climates).
•
If a sensor goes out, please wait 2-4 hours for it to reconnect on its own. Please be patient – these stations
can reconnect on, after many hours out.
•
RF (radio frequency) communication is not always 100% on. Certain temporary conditions can cause it to go
out for a time (e.g. 100% humidity).
If a miss happens:
•
If sensor loses connection to the station for any reason, the station will show dashes after 30 minutes.
•
The station will search for 5 minutes every hour to reconnect with sensor.
•
Be sure you have good
. Manually search for your sensor by holding the TEMP button.
Try this:
•
Bring your sensor within 10 feet of your station and make sure it is connected to the station.
•
After 15 minutes move the sensor into the next room with a wall between the sensor and the station for 1 hour.
•
If there is no loss of signal in that hour, move the sensor just outside.
•
Continue moving the sensor back to its original location.
•
If you lose connection, look for sources of
HOW DO I CHANGE BETWEEN FAHRENHEIT AND CELSIUS?
•
On your sensor, open the battery cover and press the F/C button. This will change the temperature display on
the sensor only.
•
to select Fahrenheit or Celsius temperature display on the station.
