La Crosse Technology T83639, Часто задаваемые вопросы

Страница: 7 / 9

La Crosse Technology, Ltd. www.lacrossetechnology.com/support Page 7
3. Press the DOWN ARROW button to disarm the selected alert.
Note: When no temperature alerts are set, the Temperature Alert area will show ALERTS OFF.
Active Temperature Alert

When temperature alert sounds, the corresponding alert icon (bell) will flash.

The alert beeps once every minute, until the temperature is out of alert range.

Press any button to stop alert. The alert symbol will still show.
Temperature Station
How tall are the time numbers?
The time numbers are 0.5 inches tall.
Power Requirements

2-AA Alkaline batteries power this temperature station.
12-Hour or 24-Hour time format

Time can display in 12-hour (am, pm) or 24-hour format.

Default is 12-hour time.

Use the Program Menu to switch time formats.
Fahrenheit/Celsius

Use the program menu to switch between Fahrenheit and Celsius.
Dashes, HH.H, LL.L or stuck Indoor Temperature
Explanation: These symbols are error messages indication the indoor sensor is outside of its readable
range. For indoor readings, this is generally a power related issue.

Batteries may be overpowered or underpowered. Remove batteries from the temperature station.

Press any button 20 times. Leave the temperature station unpowered for 1-2 hours.

Install fresh Alkaline batteries with correct polarity.

If the indoor temperature is still shows dashes, HH.H or LL.L, the temperature station may need
replacement.
Inaccurate Indoor Temperature Reading
Explanation: When the indoor temperature is inaccurate, it is often due to the location of the display or
overpowered/under powered batteries. You can test the accuracy at you home.
Side-by-side test:
Bring the outdoor sensor in the house and place it next to the temperature station for
2 hours.

Compare indoor and outdoor temperature. The temperature should be within 4 degrees to be within
tolerance.

Look for heat sources such as sunlight, door or window frames or reflected heat or cold near the
temperature station.
Check batteries .
Set Time Alarm
In normal mode, hold the TIME ALARM button for three seconds to enter alarm set mode.
1.
HOUR: The Hour will flash, use the ARROW buttons to set the hour, and press TIME ALARM button
to confirm and switch to minutes.
2.
MINUTES: The Minutes will flash, use the ARROW buttons to set the minutes, and press TIME
ALARM button to confirm.