L3Harris Narda SignalShark, Руководство пользователя

Страница: 98 / 231

SignalShark User Manual
98
Defining the stop behavior (Stop Mode)
The stop mode value changes the behavior of the measurement engine, after the Run key is
pressed.
•
Hold : Measurement continues in the background.
•
Stop : Measurement stops and runs again.
You can stop/hold the measurement using the
Run
key.
To change these parameters:
1. Tap the toggle button to select Hold or Stop .
2. Press the Esc key or tap the header to close the menu.
Setting the detectors (Detectors)
With the Detectors button, the three detectors can be set to a detector type or switched off.
Open the Detectors menu:
You selected the desired view.
1. Tap the Detectors button.
The Detectors menu opens.
2. Then you can do the following:
Detector 1, Detector 2, Detector 3
To select the detector types:
1.
Tap a detector and select from the dropdown menu:
– Detector 1 : +Pk , Off
– Detector 2 : RMS , Off
– Detector 3 : -Pk , Smp , Avg , Off
2. Press the Esc or OK key to close the dropdown list.
3. Press the Esc key to close the menu.
Mod. Detectors
To set the Mod. Detectors value:
1. Tap the Mod. Detectors button.
2. From the dropdown list, select the required value.
The setting is accepted immediately.
3. Press the Esc key to close the menu.
Post Avg.
To set the Post Avg. value:
1.
Tap the Post Avg. button.
2. Enter the required value and select a unit.
The setting is accepted immediately and the menu is closed.