COMPONENT MAINTENANCE MANUAL
AVIATION RECORDERS
FA2100CVR
Rev. 15 Page 180
Apr. 14/16
Testing & Fault Isolation
23–70–04
Use or disclosure of information on this sheet is subject
to the restrictions on the cover page of this document.
FA2100 CVR
RECORDER
RECORDER INTERFACE (RI)
CABLE ASSY.
17TES0057
AC
INPUT
DC
INPUT
FA2100 TO CICC/2
COMPUTER INTERFACE
COMMUNICATIONS CABLE
17TES0072
CICC/2
COMPUTER INTERFACE
COMMUNICATIONS CABLE/2
17TES0070
ROSE/RI SOFTWARE
17TES0321 (CDROM)
RECORDER USB FDAU
SIMULATOR (RUFS)
(RI) ADAPTER
17TES0076
READ-OUT CENTER/5, /6 or /7
17TES0300/17TES0400/17TES0700
Power
Input
Select
FA2100 SOFTWARE
DISTRIBUTION DISK
840‐EXXX‐XX
Note:
Firmware Distribution
Diskette P/N will match the
FA2100 Software Part
Number located on the
recorder 's Name Plate Label.
TO
ENHANCED
PARALLEL PORT
(EPP)
FA2100
SOFTWARE UPLOAD
(BOOTLOAD) CABLE ASSEMBLY
17TES0058
(use for software
uploading only)
Note:
RI = Recorder Interface.
ROSE = Read‐Out Support Equipment.
ROC = Read‐Out Center (ROC/5, /6 or /7)
Note:
The ROC rear connections shown in this diagram are for
general reference and may not reflect the exact connector
location or configuration your ROC system computer.
Note:
The 17TES0058 cable assembly should only be attached
during upload process. Not used when downloading data
or getting recorder status.
Figure 177.
Typical Software Upload Setup For FA2100 Recorder with CICC/2 Cable
The document reference is online, please check the correspondence between the online documentation and the printed version.