L3 Mobile-Vision Flashback3, Руководство пользователя, Страница: 244 / 280

Changing the Flashback Monitor Settings
Adjusting the Monitor Brightness Setting
Flashback3 & Flashback HD User’s Guide
P a g e 236
L3 Mobile-Vision

6.23.2017
NOTE
: If the red DIMMER display appears rather than the CONTRAST display
pictured above, it means that you accidentally pressed the button slightly ahead of
the button. Wait until the display disappears, then trying pressing + again.
2
Use the button to increase this setting in increments of five.
– OR –
Use the button to decrease this setting in increments of five.
After several seconds of inactivity, the system will automatically exit Monitor
Setup Mode.
Adjusting the Monitor Brightness Setting
The easiest way to adjust brightness is to use the or buttons on your Flash-
back monitor. Alternatively, you can access the Brightness bar while in Monitor
Setup Mode, as described below. This procedure is typically used when you are
interested in knowing the numeric value of your brightness setting.
Once you change the brightness level, it will remain at that setting until you or
another user changes it again.
Brightness levels range from 0 – 100. You can adjust this setting up or down in
increments of five (i.e., 5, 10 ,15, etc.). System default is
50 .
Before you change this setting, it’s recommended that you turn the GPS monitor
display
off , as it will make it difficult for you to see the Brightness bar. For
instructions, see “Turning the ‘GPS’ Display On/Off” on page 138.
1
Press + simultaneously to enter Monitor Setup Mode. The yellow Contrast
bar displays at the bottom of your monitor.
NOTE
: If the red DIMMER display appears rather than the CONTRAST display
pictured above, it means that you accidentally pressed the button slightly ahead of
the button. Wait until the display disappears, then trying pressing + again.
2
Press to advance to the Brightness bar.