Chapter 2 - Hand Controller Controls
TM00358 Rev. A
October 2007
L-3 WESCAM
10
All Rights Reserved
2.1
HAND CONTROLLER CONTROLS
Operators can use the Hand Controller to perform the following functions:
•
Turn turret power ON or OFF
•
Steer the turret
•
Control system sensors
•
Change mode settings
•
Access and navigate the user menus
•
View power and laser status indicator LEDs
The Hand Controller is used for the most common operator functions. All operator control descriptions, assume
default settings of the Level 2 Operator Gimbal Menu. A number of parameters in the Level 2 Operator Gimbal
Menu can be used to tailor operation of the Hand Controller; however, tailoring is optional and not normally required.
Figure 2-1 Hand Controller
2.1.1 Hand Controller – Primary Switch Controls
Figure 2-2 Hand Controller Face Plate Switches
Joystick
Face plate controls
Top buttons
Handle
Position detents
Deadman lever
IMAGE
MODE
FWD
IMAGE
INT
FILTER
AUTO
SLEW
1
2
3
4
5
6
7
8
10
11
15
16
17
12
13
14
9
