![background image](http://html1.mh-extra.com/html/l-b-white/cp400ak/cp400ak_owners-manual-and-instructions_3144166008.webp)
Front Handle
Rear Handle
Wheel Bar
Wheel Support Frame
Wheels (Semi-Pneumatic)
Wheel Caps
Cord Wraps
Screw (L)
Screw (S)
Bushings
Cotter Pins
Washers
Nut
Figure 3 – Components
DIMENSIONS & ASSEMBLY (cont.)
ASSEMBLY FOR CP400AK
TOOLS REQUIRED
• Medium Phillips screwdriver
• 3/8” open or adjustable wrench,
use US (Inch) screws nuts
• Long nose pliers
ASSEMBLING WHEEL & HANDLE
1. Slide axle through wheel support frame. Install
wheel bushings and wheel on axle.
NOTE: When installing wheels, tube valve should
face out from support frame (Figure 4).
2. Place flat washers and cotter pins on axle ends
and bend cotter pins with long nose pliers to
secure.
3. Place wheel cap on flat washers and put wheel
cap in flat washers end.
4. Place heater on wheel support frame. Make
sure air inlet end (rear) of heater is over wheels.
Align the holes on fuel tank flange. Insert screws
through handles (front and rear), fuel tank
flange, and wheel support frame as shown in
Figure 4 and attach nut finger tight after each
screw is inserted.
5. After all screws are inserted, tighten nuts firmly.
6. Align the hole on the rear handle with the
mounting hole on the cord wrap.
7. Insert screws through cord wrap, rear handle as
shown in Figure 4 and attach nut finger tight
after each screw is inserted.
8. After all screws are inserted, tighten nuts firmly.
CAUTION
Risk of fire or explosion
■
Do not operate heater without support frame fully
assembled to tank.
Figure 4 – Wheel and Handle Assembly
Screw (L)
Fuel Tank Flange
Wheel Support Frame
Wheel
(Semi-Pneumatic)
Nut
Flat Washer
Wheel Cap
Axle
Wheel Tube Valve
Cotter Pin
Bushing
Air Inlet
Screw (S)
Screw (S)
Cord Wrap
Nut
4
8