FLAT presets
FLAT presets
The transducer connected to an output channel of a FLAT preset is not protected by L-DRIVE.
The only active limitation allows minimizing clipping risks to protect the amplier.
Therefore, when driving a third party loudspeaker enclosure, it is recommended to connect an external DSP
device using a preset specically designed for this model before the amplied controller.
With a FLAT preset, an input signal is amplied and directly routed to output without any modication of the frequency
response. All the output parameters are accessible (Mute, Gain, Delay, Polarity, and Routing).
• Using the [FLAT_LA2X] preset with LA2Xi in SE mode provides 0 dB of headroom.
• Using the [FLAT_xxxx] preset with LA2Xi in BTL/PBTL modes, LA4, or LA4X provides 6 dB of headroom.
• Using the [FLAT_LA8] preset with LA8 provides 8 dB of headroom.
• Using the [FLAT_LA12X] preset with LA12X provides 9.5 dB of headroom.
[FLAT_xxxx]
outputs
channels
routing
gain
delay
polarity
mute
OUT 1
PA
IN A
0 dB
0 ms
+
ON
OUT 2
PA
IN A
0 dB
0 ms
+
ON
OUT 3
PA
IN B
0 dB
0 ms
+
ON
OUT 4
PA
IN B
0 dB
0 ms
+
ON
Routing, gain, delay, polarity and mute parameters can be modied by the user.
Preset Guide owner's manual (EN) version 16.0
31