L-Acoustics LA-RAK, Руководство пользователя

Страница: 51 / 201

Rigging procedures
2.
(Optional, see M-BUMP rigging options (p.189)) Install one or two M-BAR on the M-BUMP as follows (repeat for
each M-BAR):
a) Remove both T-BLP from the M-BAR.
b) Insert both M-BAR studs face to the desired M-BUMP holes.
c) Secure by inserting both preceding T-BLP through M-BAR studs and M-BUMP holes.
b.
c.
3.
Attach the shackle(s) to the M-BUMP (see Safety pin removal and insertion (p.199)) according to the desired
conguration (see M-BUMP rigging options (p.189)).
4. Place a full ight-case at the rigging location and remove the lid. Direct the front face of the 3-Kara array towards
the audience. In the following, the array will be designated as ARRAY#1 and the enclosures as KARA#1 to KARA#3
from top to bottom.
5.
Check the inter-enclosure connections in ARRAY#1 (repeat for each side):
a) For both front rigging points, verify that the front arm is open and locked to 2 Kara by 2 R-BLP inserted in yellow
link holes.
b) For both rear rigging points, verify that the angle arm cursor is aligned with the 0° angle value and locked to
2 Kara by 2 R-BLP, the upper one inserted in a yellow link hole and the bottom one inserted into angle hole
0°/2°/4°.
Kara owner's manual (EN) version 1.0 51