KLS24manual
www.kystar.com.cn
14
Note:
Device IP address defaults to 0 network segment, other device's IP the guarantees that the same field and
different numbers are available for normal communication. To change The network segment of IP, you need to
change the software settings now.
（3）Establish communication
in software communication, Select NET Connect , and click directly OK , if the connection
succeeds, a prompt box will pop up, as shown in the following figure, and click OK .
7.2.2
Select COM Connect
（
1
）
Wiring
Use random distribution RS230--RJ11 connector, one end attached to the processor's COM1 Port,
one end is connected to PC Serial Port (if no nine-pin serial port to use serial port to turn
USB Convert header to USB up PC 's USB port).
（
2
）
Modify COM Port
When software communicates, Select COM Connect :
