Kyoeisha Baroness LM531, Руководство по обслуживанию

Страница: 113 / 161

Seat Switch
The seat switch is located right underneath the
seat and is usually not conducted.
It is normal that there is conduction between
terminals A-B when seated (pressed).
1
2 3
6m8tje-007
Seat Switch_001
1 Seat switch
2 Terminal A
3 Terminal B
Rocker Switch
The rocker switches are located in the
operation panel and under the hood, and are
used for the reel rotation switch and reel
reverse switch.
Normal operation is when there is conduction
between sockets A and C when the reel
rotation switch is in the "Rotation" position and
the reel reverse switch is in the "Reverse
rotation" position, and no conduction between
A and C when the reel rotation switch is in the
"Stop" position and the reel reverse switch is in
the "Normal rotation" position.
1
2 3
B
C
A
A
2
3
B C
t3inzb-002
Rocker Switch_001
1 Rocker Switch
2 Conduction between A and C
3 No conduction between A and C
Proximity Switch
Proximity switches detect that objects are
nearby through non-contact methods .
1
2
lo2wbc-002
Proximity Switch_001
1 Proximity Switch
2 Plastic magnet
Proximity Switch V-in
Inspection of Control Output
Important
The output voltage of the proximity switch V-in
cannot be inspected.
Incorrect measurements will damage the
proximity switch or tester.
Checking the continuity of the proximity
switch V-in while it is energized can
determine the state of the output.
Follow the steps below to connect the
battery and a circuit tester to the
connector terminal of the proximity switch
V-in.
Connect the battery (+) to the connector
terminal (+), and the battery (-) to the
connector terminal (-).
Connect the tester (+) to the connector
terminal V-in, and the tester (-) to the
connector terminal (-).
￭
1.
[1]
[2]
Electrical System
LM531
Electrical System
Page 5-29
Electrical components