Kyocera TASKalfa 7353ci, Руководство по эксплуатации

Страница: 109 / 723

2-42
Installing and Setting up the Machine > Energy Saver Function
Sleep
To enter Sleep, select the [ Energy Saver ] key. Touch panel and all indicators on the operation panel will go out to save
a maximum amount of power except the Energy Saver indicator. This status is referred to as Sleep.
If print data is received during Sleep, the machine automatically wakes up and starts printing.
Also when fax data arrives while the machine is in Sleep, the machine automatically wakes up and starts printing.
To resume, perform one of the following actions.
• Select any key on the operation panel.
• Touch the touch panel.
• Place originals in the document processor.
Recovery time from Low Power Mode is as follows.
• 39 seconds or less
Note that ambient environmental conditions, such as ventilation, may cause the machine to respond more slowly.
Auto Sleep
Auto Sleep automatically switches the machine into Sleep if left idle for a preset time.
The amount of time before entering Sleep is as follows.
• For Europe: 20 minutes (default setting)
• Except for Europe: 45 minutes (default setting)
To change the preset sleep time, refer to the following:
Energy Saver Setup (page 2-45)
Sleep Rules (models for Europe)
You can set whether Sleep Mode operates for each function. When the machine enters Sleep Mode, the ID card cannot
be recognized.
For more information on Sleep Rules settings, refer to the following:
Sleep Rules (models for Europe) (page 8-80)
NOTE
If the Low Power Timer is equal to the Sleep Timer, a Sleep Mode is preceded.
Energy Saver indicator