2RV/2RW/2RX/2RY/3RA
6-17
(3) Toner install mode
Contents
When replacing with the new developer unit, it needs to supply toner as it is not included in the
developer unit. Though the toner is supplied automatically to the developer unit without the spe-
cific operation, it takes a long time to supply the toner inside the developer unit to the level so that
it is possible to print in the case of the new developer unit which does not contain the toner at all.
(About 200gram toner needs to reside.) In case of replacing the developer unit, it is possible to
supply toner temporally at a high speed in this mode.
Purpose
Enforce to supply the toner when replacing the developer unit.
Method
1.Open the front cover.
2.Press and hold the [Go] and [Stop] keys simultane-
ously 5 seconds or more.
3.Close the front cover. The toner installation mode is
executed.
* :When the toner installation mode is executed. it
stops the toner supply.
(4) Checking/clearing the maintenance cycle
Contents
After replacing the maintenance kit, execute this item and reset the counter in order to newly
start the count.
Purpose
Clears maintenance kit life counts.
Replacement procedures
Drum unit (See page 4-11)
Developer unit (See page 4-10)
Method
1.Open the front cover.
2.Press and hold the [Go] key 15 seconds or more.
3.Close the front cover. The maintenance counter is
cleared.
Содержание PF-1100
Страница 4: ...This page is intentionally left blank...
Страница 10: ...This page is intentionally left blank...
Страница 337: ...2RV 2RW 2RX 2RY 3RA 8 13 5 Operation panel PWB LED Connector position Figure 8 9 PWB photograph Figure 8 10 YC1 1 17...
Страница 355: ...Installation Guide PF 1100 250 sheets 1 Paper Feeder Installation Guide...