Kyocera ECOSYS PA2100cwx, Руководство по эксплуатации

Страница: 46 / 234

2-17
Installing and Setting up the Machine > Network Setup
Network Setup
Configuring the Wired Network
The machine is equipped with network interface, which is compatible with network protocols such as TCP/IP (IPv4),
TCP/IP (IPv6), NetBEUI, and IPSec. It enables network printing on the Windows, Macintosh, UNIX and other platforms.
Set up TCP/IP (IPv4) to connect to the Windows network.
Be sure to connect the network cable before configuring the settings.
Connecting LAN Cable (page 2-7)
For other network settings, refer to the following:
Network Settings (page 6-13)
IPv4 setting
1
Display the screen.
[
Menu
] key > [▲] [

] key > [
Wired Network
] > [►] key > [▲] [

] key > [
TCP/IP
] > [
OK
] key
2
Configure the settings.
1
[▲] [

] key > [
On
] > [
OK
] key
2
Select [►] key while "TCP/IP On" is displayed.
3
[▲] [

] key > [
DHCP
] > [
OK
] key > [▲] [

] key > [
Off
] > [
OK
] key
4
[▲] [▼] key > [
IP Address
] > [
OK
] key
5
Set the IP address.
6 Select the [ OK ] key.
7 [▲] [▼] key > [ Subnet Mask ] > [ OK ] key
8 Set the subnet mask.
9
Select the [
OK
] key.
10
[▲] [▼] key > [
Default Gateway
] > [
OK
] key
NOTE
You can set any value between 000 and 255.
Select the [▲] or [▼] key to enter a number.
Select the [◄] or [►] key to move the cursor left or right.
NOTE
You can set any value between 000 and 255.
Select the [▲] or [▼] key to enter a number.
Select the [◄] or [►] key to move the cursor left or right.