KYMCO MXU500i-IRS-EFI, Руководство пользователя

Страница: 41 / 163

32
TO JUMP START YOUR VEHICLE
1.
2.
3.
4.
Remove the seat and locate the batteries.
Find the po)and negative(-)terminals on
each battery.
Check that the jumper cables do not have lose
missing insulation. If they do, you could get a
shock. The vehicles could be damaged, too.
Before you connect the cables, here are some
basic things you should know. Po)will go
to po)and negative(-)will go to negative(-
)or a metal engine part. Do not c) to (-)
or you will get a short that would damage the
battery and maybe other parts, too.
Connect the red po) cable to the
po) terminal of the vehicle with the dead
battery. Use a remote po) terminal if the
vehicle has one.
Don’t let the other end touch metal. It
to the po) terminal of the good battery.
Connect
Use a remote po) terminal if the vehicle
has one.
5. Now connect the black negative(-) cable to the
good battery’s negative(-) terminal .
Don’t let the other end touch anything until the
next step. The other end of the negative cable
go to the dead battery It goes to a
heavy unpainted metal part on the engine of the
vehicle with the dead battery.
Now start the vehicle with the good battery
and run the engine for a while.
Try to start the vehicle with the dead battery.
If won’t start after a few tries, it probably needs
service.
Remove the cables in reverse order to prevent
electrical shorting. Take care that the don’t
touch other or any other metal.
doesn’t
6.
7.
8.
.
NOTE:
If the other system isn’t a 12-volt system or
With a negative ground, both vehicles can
be damaged.