10
z
KIEN3016APanel
Mounting
The specific steps are as follows:
Step 1: Select the mounting position for KIEN3016A on the wall or in cabinet;
ensure that there is adequate space for the switch.
Step 2: Drill 4 holes on the selected position according to the panel mounting
dimension drawings; use a cross-screwdriver to screw 4 cross-slot screws
(M3×10) into holes. Don’t tighten the screws completely; leave about 5mm of
space between.
Step 3: Aim 4 mounting holes on KIEN3016A mounting plate at 4 fixed screws;
pass the screws through 4 holes with the diameter of 6.5mm (
Ф
6.5); then slide
down KIEN3016A as seen below; finally screw 4 screws tightly. Now the
KIEN3016A should be firmly fixed to the wall or cabinet.
Figure 8 Panel Mounting
z
Remove KIEN3016A from wall or cabinet
The specific steps are as follows:
Step 1: Use a screwdriver to loosen 4 screws; move the device up to let
screws into 4 holes with the diameter of 6.5mm (
Ф
6.5).
Step 2: Unscrew the screws from wall or cabinet; remove the device from wall