60
Chapter 7 - FM (VHF) Measuring Range
10713 Vxx.11
7.3
Stereo indicator
The stereo decoder of the VHF receiver evaluates the 19 kHz pilot signal. If a pilot is present,
STEREO
appears in the top line;
MONO
is otherwise displayed.
Figure 7-2 VHF stereo indicator display
7.4
RDS (Radio Data System)
RDS is the counterpart to videotext for TV. Additional to audio, digital data are transmitted. These
are modulated up to a 57 kHz subcarrier in PSK (Phase Shift Keying). The RDS specification
comes from the standard EN50067.
These data are sent in what are referred to as groups. Every group transmits different information.
The repetition rate of every group also differs.
The measuring receiver evaluates only the groups of type 0A, 0B, 2A and 2B. Groups 0A or 0B
make up approx. 40% of the total data. The proportion with groups 2A and 2B is only 15%. Among
other data, the program name is transmitted with a maximum of 8 characters in groups 0A and 0B.
The program name (e.g. “Bayern 3") is shown in the top line of the display. In addition to the
program name, the PI (Program Identification) code is shown in the top line of the display. The PI
code is used as unique identification of the radio programs.
7.5
Scan
You can use this function to scan the entire range (87.40...108.20 MHz) for VHF broadcast signals.
You start the scan by first tuning the measuring receiver to a frequency at which the scan should
begin. After entry of a new channel, the menu item
2.FUNCTION
is inverted. The arrow key can be
used to set the frequency or interrupt a measurement that is currently running. To start the scan,
first press the
F2
key in order to activate the first function of the arrow keys. Press the
↑
key to start
the scan in the positive direction. Press the
↓
key to do the same in the negative direction. When
the band limit is reached, the scan continues at the other end of the range. You can end the scan at
any time by pressing
ENTER
. “SCAN” is shown on the display while the scan takes place.