Kwikbit K60x, Руководство пользователя

Страница: 18 / 44

K60x User Guide
18 K60x User Guide
5.2 Pre-installation Setup and IP Configurations
K60x units have a default configuration loaded at the factory. If you are not using the Edge
Controller to set up your network, you must configure each unit before installation using its
factory-set IP address to access one of the other
Management Interface options : WebUI or
CLI .
This section shows how to perform common pre-installation configuration tasks, using the
WebUI.
See Management Functions for additional settings and status information.
Typical settings for initial configuration of the K60x
WebUI Tab Setting Comments
Wireless Device Role Required.
SSID Required.
Airlink encryption passcode Required.
Center frequency Recommended for hub units.
Admin Change Password Optional, but highly recommended.
Location Optional, but highly recommended.
Description Optional, but highly recommended.
Network IP assignment method Setting may be required by your
organization’s network policy.
Optional for operation.
IP address Required when IP address method is set
to Static.
Network mask Required when IP address method is set
to Static.
Network gateway Required when IP address method is set
to Static.