KWB Easyfire, Руководство по установке и обслуживанию, Страница: 120 / 220

© KWB – Kraft und Wärme aus Biomasse GmbH IM Easyfire 10/2008 Page 121
12 Pellet Stirrer Plus 12 Pellet Stirrer Plus
5.) Transfer the length of the conveyor worm
Transfer the measured distance to the conveyor worm.
Attention! Always take the dimension from the centre bore.
Attention! The end of the worm with the bore should always point
in the direction of the boiler room in installed status. Do not install
a worm that is cut off or twisted under any circumstances!
6.) Cut the conveyor worm to size
Cut off the conveyor worm with 90° angle grinder.
Deburr the cut edges.
7.) Mount the drilling template
Mount the drilling template on the shaft joint.
8.) Install conveyor trough
Connect the conveyor worm of the stirrer to the connecting
FE components: For example:
• Front conveyor worm of the extensions
• Drive shaft for suction conveyor or
• Drop shaft
Attention! To do this always use the worm end with the prepared
bore!
Prior to executing step 9, bearing and drive motor must be installed.
9.) Bore the stirrer worm
Thread the conveyor worm onto the shaft for stirrer. Between shaft
joint and worm a max. distance of approximately 20 mm should be
adjusted. Drill a passage bore 8 mm. Use the drilling template as a
centring element.
Attention!
Ensure that the position of the conveyor worm relative to the
existing intermediate bearings is correct. If necessary adjust the
worm or gear unit longitudinally!
Attention!
Do not use the worm end with the bore on the gear unit side under
any circumstances!
MA-Easyfire 10.2008_EN.indd 121 MA-Easyfire 10.2008_EN.indd 121 30.03.2009 13:31:08 Uhr 30.03.2009 13:31:08 Uhr