TracVision TV1 User’s Guide
35
Receiver Settings
Configuring a Linear Receiver for Automatic
Switching
For automatic satellite switching to work properly using the DiSEqC
communication protocol, you need to set up your receivers for the
same satellites you installed in the TracVision antenna. Be sure to set
up the satellites in the receiver in the exact same order as they were set
up in the antenna. The specific setup process varies among receiver
models – refer to your receiver owner’s manual for details. Use the
table and figure below as a guide.
Figure 5-1 Linear Receiver DiSEqC Settings (Example)
Satellites in Antenna
Matching Satellites in Receiver
Slot A
Port/Switch/LNB/DiSEqC 1 or A
Slot B
Port/Switch/LNB/DiSEqC 2 or B
Slot C
Port/Switch/LNB/DiSEqC 3 or C
Slot D
Port/Switch/LNB/DiSEqC 4 or D
Содержание TracVision TV1
