KVH, TracVision, and the unique light-colored dome with dark contrasting baseplate are registered trademarks of KVH Industries, Inc.
All other trademarks are property of their respective companies. The information in this document is subject to change without notice.
No company shall be liable for errors contained herein. © 2017 KVH Industries, Inc., All rights reserved.
54-0667 Rev A | 72-0429 and 72-0430
1
TracVision HD7 LNB
Replacement Instructions
Technical Support
If you need technical assistance, please contact KVH Technical Support:
North/South America, Australasia:
Phone: +1 401 847-3327
Email: [email protected]
Europe, Middle East, Africa, Asia-Pacific:
Phone: +45 45 160 180
Email: [email protected]
The following instructions explain how to replace
the LNB in a TracVision
®
HD7 antenna.
NOTE: Your antenna might have parts that differ from
those pictured in this document. Such differences have no
bearing on the instructions unless noted otherwise.
Tools Required
This procedure requires the following tools:
• #2 Phillips screwdriver
• 5/16" open-end or box wrench
• 7/16" open-end or box wrench
• 11/32" open-end or box wrench
• Flush cutters
• 7 mm open-end wrench (
supplied in kit
)
• #2 Phillips torque screwdriver or torque
wrench with a 11/32" hex bit set to 21 in.-lbs
• Torque wrench with:
5/16" bit (11 in.-lbs)
7/16" bit (15 in.-lbs)
7 mm hex bit (11 in.-lbs)
Figure 1: HD7 LNB
