5
Pack the ICM
You
must
return the following components:
Follow the instructions below to prepare the ICM
for reshipping.
a.
Remove the power cable, Wi-Fi antenna(s),
and strain-relief bracket from the ICM.
NOTE:
When returning the silver ICM (see lower
ICM photo above), also remove the RF terminator
from the J4 “Rx RF” jack, and remove the locking
Ethernet jumper cable from the B1 and B2 jacks (use
an extraction tool).
b.
Place the ICM in a polybag. Then place the
strain-relief bracket against the bottom of the
ICM and enclose the ICM and bracket with
or
Integrated CommBox Modem
(ICM)
Quantity: 1
IEC320-C14 to IEC320-C13
adapter cable, 6.5 ft (2 m)
Quantity: 1
IEC320-C14 to NEMA5-15P
adapter cable, 7.5 ft (2.2 m)
Quantity: 1
European power cable, 8.2 ft (2.5 m)
Quantity: 1
Strain-relief bracket
Quantity: 1
Wi-Fi antenna
Quantity: 2
Figure 6: Foam End Caps for the ICM and Bracket
