Adjustments
34
Adjusting the
opener disc
The opener disc opens the line ans cuts off residues to facilitate the
work of the waste clearers.
Lift the machine up.
Stabilise the machine.
Remove safety pin (A).
Insert the KV key into the screw head (B), in order to make the
adjustment.
Take the key.
Remove pin (C).
Adjust the item to the desired height:
Raise the element to reduce the working depth.
Lower the item to increase the working depth.
Replace pin (C).
Replace safety pin (A).
Make the same adjustment on each row.
Adjusting the
waste clearer
The waste clearer cleans the line of residues present on the land
Lift the machine up.
Stabilise the machine.
Pull the pin (A).
Adjust the item to the desired height:
Raise the item to reduce the pressure on the ground.
Lower the item to increase the pressure on the ground.
Set the pin in the desired position.
Make the same adjustment on each row.
To allow the waste clearer to float:
Pull the pin (A).
Place the pin in the notch (B) on the arm.
•
In the upper position the waste clearer is disengaged.
•
In the lower position the waste clearer exerts maximum pressure
on the ground.
A
B
C
B
A